Why I made this tutorial: Ok- then basically I had this annoying chimera on my tempered glass screen protector. It had in the centre of it what looks like a little bit from the glass, which I later institute out after removing the screen protector was dust. And then- to clean it I used the micro-fibre cloth. Big fault. All of the $.25 of dust on it just got stuck to the gluey side of the screen protector, so I'll just walk people though how to do it right and clean dust off without, well, adding more than- because when I reapplied it the first time it was fifty-fifty worse. Disclaimer: This tutorial was written based off of my experience with a Tempered Glass screen protector- not sure how well it works with a normal one, if anyone tries information technology with a normal plastic one delight permit me know how it goes, but it should work the same.
Tutorial:
i. And then beginning you'll want to remove your screen protector- the more dust free the area, the better. I'd recommend turning off whatever fans and doing it at a clean workspace/desk/whatever. (If for some reason yous're screen protector is dust costless after removal- skip to step 6)
2. At this point y'all'll need gluey tape (any type volition work- I heard yous need to use packing tape only normal office record worked fine, if not better, for me and is more readily available).
three. Now gluey record the non-sticky side downward and then that when removing the strips of tape one by ane from the other side, it won't lift off of the table/workspace and you lot won't take to utilise your hands to hold it down, getting information technology dirty and defeating the whole point of doing this in the commencement place.
4. Now place a strip of viscous record beyond the sticky side of the screen protector, make sure it'southward actually stuck t the screen protector, then pare information technology off. Make sure that you practise this over and over, until you have gotten the whole of that side. This will safely remove all dust, fingerprints and other things from the sticky side of the screen (and the non-viscous side, only the normal side the micro-fibre cloth is easier to use on that side as it has no stickiness to catch the small $.25 of it that can come off).
5. Once you lot've done this across the whole of the side, check for whatever remaining dust, if in that location is any, just reapply tape there and peel it off.
half-dozen. Make sure you're devices screen is make clean, specifically of grit and small particles that will cause air bubbles- and fingerprints and smudges that will just be annoying. Also you can remove the tape from the non-gluey side of the screen protector that was property it down, every bit it is no longer needed.
7. Now yous can reapply the screen protector, if it isn't gummy plenty to stick- there are multiple ways around this. I didn't see it as the sticky record actually added stickiness (you may desire to attempt that if you lot skipped to pace 6), but apparently in a room total of steam y'all can practice a "dry out install", but the steam method doesn't sound as good, and I experience like it would probably fog up the screen protector a flake, plus I don't feel similar putting my phone in a steamy room, and so simply exercise this if the other method doesn't work.
8. Now use the tool that OnePlus provided (or if yous don't have that, a ruler may work but your hands is fine) to button air bubbling off to the side and out, if one won't go and it looks like there is like a chip in the screen protector, that is probably dust, so restart if y'all want to get rid of information technology and pushing it off won't work.
Enjoy your now-clean screen protectors without whatever bubbles! I promise this guide helped, if you need help or I wasn't clear enough please post below and I will get back to you lot ASAP.
Post a Comment for "How to Get My Privacy Screen to Stick Again"